Using the standard fixture kit provided by CHD to make standard test fixtures and customized test systems, you can achieve high-quality testing in a short period of time. The test fixtures are perfectly matched with our test system units.

To ensure the high quality and perfect function of PCBs, electronic components, and finished products, these products need to be tested with the latest testing equipment for specific functional requirements. This can be done during the production process or after the production assembly.The end-of-line test system (EOL) can reliably test the function of finished products and components. There is no problem with the combination of PCBA functional testing (FCT) and online circuit testing (ICT). During ICT testing, the lines and independent components of the PCBA are contacted through test points and checked to see if there are any defects in the lines and various components of the PCBA board.

During FCT testing, the function of the device under test (DUT) is achieved through test point contact instead of the finished product connector to implement functional testing at the PCBA stage. FCT testing greatly improves the test coverage of PCBA, as FCT testing is the functional testing of PCBA, which is responsible for the assembly process or has Coating/Potting such as coating process products. FCT testing can greatly improve the yield rate of finished products and reduce the cost of scrapping due to PCBA defects.

In addition to the above FCT/EOL test fixtures and test systems, CHD also provides online burning equipment, automatic inline handler to match inline test fixtures for Flashing/FCT/EOL testing processes in the production manufacturing process.

High test quality and fast changing time - CHD's test fixtures are fully compatible with CHD test handler units. In many cases, they can also be used for test handler units from other suppliers.

The inline handler test unit for production line operation can be flexibly used for circuit testing as well as functional and terminal testing of PCBs, electronic components, and equipment. The test points of PCBA can be on one side, both sides, or in step with multi-panel. All components can be matched with each other to achieve the best match and can be integrated into custom test and assembly lines.

CHD's test unit has a servo-driven (toggle lever press) Y-drive structure that provides very stable downforce pressure, with a maximum pressure of 5000N. It is also equipped with a fast pushrod (optional). It can achieve a processing time of less than 6 seconds for fast PCBA transmission in each step, providing up to 3,000 test paths.